Crayon Travel Case ... Updated

So I posted earlier about the crayon travel case.  It was pretty simple and turned out not too shabby, but I didn't like how you could see the crayon pockets from the outside of the book...so I made some changes and here's the updated version.

Materials needed (same as before):

(Book)

2 pieces fabric 7 1/2" x 15 1/2"

1 piece interface 7 1/22" x  15 1/2"

(Pocket)

1 piece fabric 6" x 15 1/2"

1 piece interface 3" x 15 1/2" (optional)

(Ribbon)

1 piece 17-18"

1 piece 11-12"

 

Iron interface to wrong side of pocket (if using interface for pocket).

[not pictured]: Iron interface to wrong side of one piece for the book

Fold pocket in half, right side facing OUT

Sew a 1/4" seam along the FOLDED edge

place the pocket on the piece of the book that does NOT have the interface...align edges and bottom (raw edges of pocket to the bottom of the book)

Measure and mark (5 1/4" from the right, 5 1/4" from the left (mark the top of the book, and the pocket).

 This is where you might find it tricky, but it's really not.  Once you have the book measured into thirds, go to the pocket and measure (starting from the inside) every 7/8" for the crayons.  Do this for both sides (see where I put the 7/8" mark on the right side of the pocket?...you'll want to start sewing there, not at the very inside mark). 

see how I started at the second measurement from the inside?

Place the ribbons on, short one first [unlike photo], then long one...make sure the seams (if applicable) face out

Place the other piece of the "book" on top, interface facing out..Sew around using a 1/4" seam allowance and leave a 2" hole where the ribbons come out

cut excess off edges & corners

turn right side out, push out corners

make sure to fold in the hole

iron

sew around the edges, 1/4" seam allowance (the most outside seam from the pocket should match up as you sew along the edge)

now, sew all the way down those two middle markings (they should now be just at 5" from either side..making each section 5")

And now you're done:)

Like I said, this was a little bit harder, but not really by much.  It was just measuring and starting from the inside to sew the crayon pockets.  But, I like the finished product much more, it has a cleaner look when the book is closed.

Happy sewing (and coloring for the kids)!

Crayon Travel Case

 So my sister told me her kids could use one of those crayon travel cases (I've seen them all over, the little crayon roll ups).  Well, I thought, "since I'm a stay-at-home mom now, I have time to make them."  Yesterday I headed over to JoAnn's and got some fabric (their favorite colors)...and I bought some crayons at Smith's for 99 cents a pack...

I looked all over for the right tutorial.  There are the crayon roll ups, the crayon and paper books, and finally I found this tutorial.  It looked like the easiest to follow (for the most part) and had the idea that I wanted.

Sew (lol), here is what I did.  The first one took a bit of time, trying to figure out all the little details, but after that, the others came together quite quickly.

You will need:
Fabric:
    2 pieces 15 1/2" x 7 1/2"
    1 piece 15 1/2" x 6"
Interface:
    1 piece 15 1/2" x 7 1/2"
    1 piece 15 1/2" x 3 (optional)
Ribbon (I used extra fabric so it would match):
     1 piece 11-12"
     1 piece 17-18"
 

The materials I got to make three books...I got a full yard of the hand fabric & the interface, and a 1/2 yard of the solid colors (definitely had leftover). Iron all your fabric first.

Cut two pieces the fabric 15 1/2" long

and 7 1/2" wide

Cut the "pocket" 6" wide

and 15 1/2" long

Here are the pieces I'll work with to make one book...the two solids (for the front & back) & interface, the pocket & interface (I used interface for the pocket to make it a bit stronger and because the fabric was a little see-through).

[directions on how to use interface]

Iron the interface to one piece of the "book" fabric

[not pictured: place interface on wrong side of "pocket".  Iron, then fold in half (wrong sides together)]

sew 1/4" seam along the folded edge of the pocket (this seemed confusing as to why do this, but it makes sense I promise)

see...

place the right side of the "book" and the "pocket" (folded/sewn side at the top) together

put the "ribbon" or ties (I used extra fabric so it'd match), long one, then short one on top [sidenote: make sure to place them ABOVE the pocket...unlike what I did]

then place the other piece of the "book" on top (right sides together, so you're looking at the wrong side)

sew 1/4" around the entire thing, but leave a 2" gap where the ribbon comes out on the side

the hardest part was turning it right sides out.

that's the 2" hole...

fold it in so you can't tell...

sew around the whole thing with a 1/4" seam [see how the ribbon is coming out of the pocket...oops!]

fold it in thirds and iron each crease

see the creases

sew down the crease

I measured 7/8" for each crayon.

And there you have it...

Cute all folded up

place a pad of paper (where the crayon box is) and put the crayons on either side

 Hopefully that helps...at least it helps me.

Total Cost: $18
Total Time: 3 hours (to figure it out)